针对双向潮流能有效利用问题,设计一种基于对称翼型的新型后掠式水平轴潮流能水轮机,并研究其水动力性能。根据对称翼型升阻力特性与叶片展向攻角变化,采用变截面设计优化后掠式对称翼型叶片,并基于Buhl修正模型分析不同后掠偏移叶片所受推力与获能特性。通过3D建模与水槽实验,研究不同后掠偏移叶片的载荷与获能情况。模型实验研究表明,同一尖速比下,后掠偏移量为10%和15%的水轮机相对于偏移量为5%的水轮机所受推力最大分别降低4%和13.3%,获能效率最多分别减小3.8%和11.1%,其中推力比获能效率减幅更大。实验结果与理论分析变化趋势吻合,但减幅比理论值偏高。此外,该水轮机3种后掠偏移量下对应获能效率随桨距角的增大分别降低18%、14%和6%,获能效率下降显著,与300 kW样机实海况运行情况变化趋势相同。
Abstract
To capture the bidirectional tidal current energy effectively, a novel swept-back horizontal-axis tidal stream turbine based on symmetrical airfoils was designed and its hydrodynamic performance was discussed. According to the lift-drag characteristics of the symmetrical airfoils and the different spanwise angle of attack, the backward swept blade was optimized by a variable section design, and the thrust and captured energy of the rotor with different offset blades were analyzed based on the Buhl model. Through 3D modeling and flume experiment, the load and captured energy of the rotor model are presented. The experiment results show that at the same TSR, the thrust of the turbine with backward swept offset of 10% and 15% is reduced by 4% and 13.3%, respectively, compared with the turbine with 5% offset. Meanwhile, the energy harvesting efficiency is reduced by 3.8% and 11.1%, respectively. In contrast, the thrust ratio has a greater reduction than the energy harvesting coefficient. The variation trends of the experimental results are consistent with that of the theoretical analysis, but the reduction range is higher than that of the latter. In addition, the corresponding energy harvesting efficiency of the turbine under the three sweep offsets decreases by 18%, 14%, and 6% with the increase of the pitch angle, the trend of which is the same as that of the field test of the 300 kW prototype.
关键词
潮流能 /
水轮机 /
对称翼型 /
后掠式叶片 /
水动力载荷 /
获能效率
Key words
tidal current energy /
tidal stream turbine /
symmetrical airfoil /
backward swept blades /
hydrodynamic load /
energy conversion efficiency
{{custom_sec.title}}
{{custom_sec.title}}
{{custom_sec.content}}
参考文献
[1] 王世明, 李淼淼, 李泽宇, 等. 国际潮流能利用技术发展综述[J]. 船舶工程, 2020, 42(S1): 23-28, 487.
WANG S M, LI M M, LI Z Y, et al.Development overview of international tidal energy utilization technology[J]. Ship engineering, 2020, 42(S1): 23-28, 487.
[2] 张亮, 李新仲, 耿敬, 等. 潮流能研究现状2013[J]. 新能源进展, 2013(1): 53-68.
ZHANG L, LI X Z, GENG J, et al. Tidal current energy update2013[J]. Advances in new and renewable energy,2013(1): 53-68.
[3] 马舜, 李伟, 刘宏伟, 等. 水平轴潮流能发电机组变桨距系统研究[J]. 太阳能学报, 2011, 32(11): 1605-1610.
MA S,LI W, LIU H W, et al.Study on blade pitching system for horizontal axis tidal current turbine[J]. Acta energiae solaris sinica, 2011, 32(11): 1605-1610.
[4] 陈健梅, 吴百公, 朱挽强, 等. 水平轴潮流能无源自适应双向流叶片设计与研究[J]. 太阳能学报, 2018, 39(12): 3295-3301.
CHEN J M, WU B G, ZHU W Q, et al.Design and research of passive adaptive bidirectional flow blade for horizontal axis tidal current energy[J]. Acta energiae solaris sinica, 2018,39(12): 3295-3301.
[5] 张萧. 共水平轴潮流能自变距双透平技术研究[D]. 长春: 东北师范大学, 2013.
ZHANG X.The study of con-horizontal tidal current self-pitch turbine with dual rotor[D]. Changchun: Northeast Normal University, 2013.
[6] KAYA M N, KOSE F, INGHAM D, et al.Aerodynamic performance of a horizontal axis wind turbine with forward and backward swept blades[J]. Journal of wind engineering & industrial aerodynamics, 2018, 176: 166-173.
[7] KHALAFALLAH M G, AHMED A M, EMAM M K.CFD study of some factors affecting performance of HAWT with swept blades[J]. International journal of sustainable energy, 2015, 36(5): 489-501.
[8] SHEN X,YANG H, CHEN J G, et al.Aerodynamic shape optimization of non-straight small wind turbine blades[J].Energy conversion and management, 2016, 119: 266-278.
[9] AMANO R, AVDEEV I, MALLOY R, et al.Power,structural and noise performance tests on different wind turbine rotor blade designs[J]. International journal of sustainable energy, 2013, 32(2): 78-95.
[10] 余龙, 张仕骏, 兀丰凯, 等. 海流发电机翼型研发进展及优化设计研究[J]. 船舶工程, 2014(4): 1-5.
YU L, ZHANG S J, WU F K, et al.Research & development and optimization design of hydrofoil of marine current turbine[J]. Ship engineering, 2014(4): 1-5.
[11] ZHU F W, DING L, HUANG B, et al.Blade design and optimization of a horizontal axis tidal turbine[J]. Ocean engineering, 2020, 195: 106652.
[12] SHELDAHL R E,KLIMAS P C.Aerodynamic characteristics of seven symmetrical airfoil sections through 180-degree angle of attack for use in aerodynamic analysis of vertical axis wind turbines[R]. Sandia National Labs, Albuquerque, NM(USA), 1981.
[13] VERELST D R S, LARSEN T J. Load consequences when sweeping blades-a case study of a 5 MW pitch controlled wind turbine[R]. Technical University of Denmark,Denmark, 2010.
[14] HANSEN M.Aeroelastic properties of backward swept blades[C]//49th AIAA Aerospace Sciences Meeting Including the New Horizons Forum and Aerospace Exposition, Orlando, FL, USA, 2011.
[15] 尹佐明, 康顺. Buhl修正模型对轴向诱导因子的影响[J]. 中国电力教育, 2008(S3): 630-632.
YIN Z M, KANG S.The influence of Buhl modified model on axial induction factor[J]. China electric power education,2008(S3): 630-632.
[16] OLIVEIRA H A, DE SOUZA RIBEIRO L A, VAZ J R P,et al. Comparative study of different correction methods to analyze wind turbine performance[C]//2019 IEEE 15th Brazilian Power Electronics Conference and 5th IEEE Southern Power Electronics Conference (COBEP/SPEC),Santos, SP, Brazil, 2019.
[17] LARWOOD S, ZUTECK M.Swept wind turbine blade aeroelastic modeling for loads and dynamic behavior[C]//Windpower 2006, Pittsburgh, PA, USA, 2006.
[18] 沈昕, 竺晓程, 杜朝辉. 叶片弯掠对风力机气动性能的影响[J]. 工程热物理学报, 2011, 32(9): 1481-1484.
SHEN X, ZHU X C, DU C H.The influence of the swept and leaned blade to the aerodynamic performance of horizontal axis wind turbine[J]. Journal of engineering thermophysics, 2011, 32(9): 1481-1484.
[19] WRIGHT A K,WOOD D H.The starting and low wind speed behaviour of a small horizontal axis wind turbine[J]. Journal of wind engineering & industrial aerodynamics,2004, 92(14-15): 1265-1279.
基金
国家重点研发计划（2018YFB1501903-03）; 国家海洋局海洋可再生能源专项（ZJME2013ZB02）
PDF(2321 KB)
