STRESS COUPLING ANALYSIS OF BLADES WITH CRACK DAMAGE UNDER SHEAR FLOW

Jiao Nianpeng; Song Li; Chen Yongyan; Jiao Xiaofeng; Feng Rui; Tian Rui

doi:10.19912/j.0254-0096.tynxb.2021-0800

PDF(2723 KB)

Acta Energiae Solaris Sinica ›› 2023, Vol. 44 ›› Issue (1) : 203-210. DOI: 10.19912/j.0254-0096.tynxb.2021-0800

STRESS COUPLING ANALYSIS OF BLADES WITH CRACK DAMAGE UNDER SHEAR FLOW

Jiao Nianpeng^1,2, Song Li^1-3, Chen Yongyan^1-3, Jiao Xiaofeng⁴, Feng Rui⁴, Tian Rui^1-3

Author information +

History +

Abstract

In view of the failure phenomenon of wind turbine with crack damage during operation, the shear flow was taken as the inlet condition, and the stress distribution law of wind turbine blade with different forms of crack damage was analyzed based on the principle of fluid-structure coupling. Through the field experiment of UAV （unmanned aerial vehicle）,it was found that the cracks were mainly concentrated in the blade root （r/R=0.10 section） and the trailing edge of the blade middle （r/R=0.50 section）. The stress of single blade reaches the maximum at 30° azimuth angle, and the crack stress at blade root reaches the maximum at rated wind speed, which is 33.34 MPa. Under strong wind speed, the crack force distributed in the blade is the maximum, which is 44.31 MPa. The gravity load mainly affects the force at the root of the blade, while the aerodynamic load mainly acts on the blade. The higher the wind speed is, the easier the crack in the middle part of the blade is to propagate. At the same time, the crack distributed along the chord has the strongest growth tendency. For the crack at the blade root, if the blade fails, the crack length shall be 1/2 of the chord length and the depth shall reach 1/2 of the blade thickness; for the crack at the middle of the blade, if the blade fails, the crack length shall reach 3/8 of the chord length and the depth shall reach 1/3 of the blade thickness.

Key words

wind turbine blades / cracks / stress analysis / shear flow / UAV detection

Cite this article

EndNote

Ris (Procite)

Bibtex

Download Citations

Jiao Nianpeng, Song Li, Chen Yongyan, Jiao Xiaofeng, Feng Rui, Tian Rui. STRESS COUPLING ANALYSIS OF BLADES WITH CRACK DAMAGE UNDER SHEAR FLOW[J]. Acta Energiae Solaris Sinica. 2023, 44(1): 203-210 https://doi.org/10.19912/j.0254-0096.tynxb.2021-0800

References

[1] 陈雪峰, 郭艳婕, 许才彬, 等. 风电装备故障诊断与健康监测研究综述[J]. 中国机械工程, 2020, 31(2): 53-67.
CHEN X F, GUO Y J, XU C B, et al.Review of fault diagnosis and health monitoring for wind power equipment[J]. China mechanical engineering, 2020, 31(2): 53-67.
[2] 杨瑞, 全佩, 张康康. 风切变效应对风力机叶片结构性能的影响分析[J]. 机械设计与制造, 2021(5): 172-175.
YANG R,QUAN P, ZHANG K K.Analysis of influence of wind shear effect on structural performance of wind turbine blades[J]. Machinery design and manufacture, 2021(5): 172-175.
[3] CHENG Y, XUE Z, JIANG T, et al.Numerical simulation on dynamic response of flexible multi-body tower blade coupling in large wind turbine[J]. Energy, 2018, 152(Jun. 1): 601-612.
[4] 温斌荣, 魏莎, 魏克湘, 等. 风切变和塔影效应对风力机输出功率的影响[J]. 机械工程学报, 2018, 54(10): 124-132.
WEN B R, WEI S, WEI K X, et al.Influences of wind shear and tower shadow on the power output of wind turbine[J]. Journal of mechanical engineering, 2018, 54(10): 124-132.
[5] 陈晓明, 康顺. 偏航和风切变下风力机气动特性的研究[J]. 太阳能学报, 2015, 36(5): 1105-1111.
CHEN X M, KANG S.Research on aerodynamic characteristics of wind turbines under yaw and wind shear[J]. Acta energies solaris sinica, 2015, 36(5): 1105-1111.
[6] 王胜军, 张明明, 刘梦亭, 等. 切变入流风况下风力机尾流特性研究[J]. 工程热物理学报, 2014(8): 1521-1525.
WANG S J, ZHANG M M, LIU M T, et al.Research on wake characteristics of wind turbine under shear inflow wind condition[J]. Journal of engineering thermophysics, 2014(8): 1521-1525.
[7] SANTO G, PEETERS M, PAEPEGEM W V, et al.Dynamic load and stress analysis of a large horizontal axis wind turbine using full scale fluid-structure interaction simulation[J]. Renewable energy, 2019, 140(9): 212-226.
[8] 顾永强, 冯锦飞, 贾宝华, 等. 损伤风机叶片模态频率变化规律的试验研究[J]. 噪声与振动控制, 2020, 40(3): 89-92.
GU Y Q, FENG J F, JIA B H, et al.Experimental study on the variation law of modal frequencies of damaged blades of wind turbines[J]. Noise and vibration control, 2020, 40(3): 89-92.
[9] 周勃, 张亚楠, 王琳琳, 等. 基于流固耦合的风力机叶片裂纹扩展机理研究[J]. 流体机械, 2017, 45(8): 19-23.
ZHOU B, ZHANG Y N, WANG L L, et al.Study on crack growth mechanism of wind turbine blade based on fluid solid coupling[J]. Fluid machinery, 2017, 45(8): 19-23.
[10] ZHOU B, ZHANG Y N, CHEN C Z.Acoustic emission detection of fatigue cracks in wind turbine blades based on blind deconvolution separation[J]. Fatigue and fracture of engineering materials and structures, 2017, 40(6): 959-970.
[11] 党永利. 风力机叶片动态特性及气弹稳定性分析[D]. 呼和浩特: 内蒙古工业大学, 2019.
DANG Y L.Analysis of dynamic characteristics and aeroelastic stability of wind turbine blades[D]. Hohhot: Inner Mongol University of Technology, 2019.
[12] 任年鑫, 李玉刚, 欧进萍. 浮式海上风力机叶片气动性能的流固耦合分析[J]. 计算力学学报, 2014, 31(1): 91-95.
REN N X, LI Y G, OU J P.Fluid-solid coupling analysis of aerodynamic performance of floating offshore wind turbine blades[J]. Chinese journal of computational mechanics, 2014, 31(1): 91-95.
[13] 邢帅恒. 风力机复合材料叶片铺层结构动力学分析[D]. 湘潭: 湘潭大学, 2013.
XING S H.Dynamic analysis of composite blade laying structure of wind turbine[D]. Xiangtan: Xiangtan University, 2013.
[14] TIAN K Q, SONG L, JIAO X F, et al.Aeroelastic stability analysis and failure damage evaluation of wind turbine blades under variable conditions[J]. Energy sources, part A: recovery, utilization, and environmental effects, 2021, 22(5): 1-19.
[15] 赵元星, 汪建文, 白叶飞, 等. 切变来流下风力机叶片应力耦合性分析[J]. 工程热物理学报, 2019, 40(11):122-129.
ZHAO Y X, WANG J W, BAI Y F, et al.Stress coupling analysis of wind turbine blades under wind shear flow[J]. Journal of engineering thermophysics, 2019, 40(11): 122-129.
[16] 宋力, 党永利, 谢晓凤, 等. 基于流固耦合的风力机叶片模拟分析[J]. 可再生能源, 2019, 37(10): 1546-1550.
SONG L, DANG Y L, XIE X F, et al.Simulation analysis of wind turbine blade based on fluid-structure coupling[J]. Renewable energy resources, 2019, 37(10): 1546-1550.
[17] 彭英, 杨平, 柯叶君. 基于XFEM的平板斜裂纹动态扩展数值模拟[J]. 武汉理工大学学报(交通科学与工程版)2019, 43(2): 222-225.
PENG Y, YANG P, KE Y J.Numerical simulation of dynamic propagation of inclined cracks in plate based on XFEM[J]. Journal of Wuhan University of Technology (transportation science and engineering), 2019, 43(2):222-225.
[18] 王静. 复合材料风机叶片结构校核理论及数值仿真方法研究[D]. 成都: 西南交通大学, 2011.
WANG J.Research on the theory and numerical simulation method of composite material fan blade structure[D]. Chengdu: Southwest Jiaotong University, 2011.