为分析气动外形参数小幅度变化对风电叶片气动与结构特性的影响,以某5 MW海上风电叶片为研究对象,构建叶片CFD（计算流体力学）气动模型与复合材料有限元结构模型,考虑某个翼型参数改变引起其所在叶素段曲面形状变化的几何约束,在满足展向光顺性工程约束的前提下,计算不同位置叶素段翼型弦长与扭角的试验水平改变量,设计气动外形参数交互作用下的正交试验方案,采用极差分析和方差分析方法,选取来流风速分别为8.0、11.4、14.0 m/s的3种工况,分析气动外形参数对风电叶片气动扭矩和叶尖挠度的影响。结果表明,气动外形参数3%的试验水平改变量,能影响约6.7%的气动性能改变和约15.0%的结构性能改变;不同位置段气动外形参数主效应不同;不同位置段参数间的交互作用对叶片气动扭矩和叶尖挠度有着不同程度的影响。
Abstract
To analyze the effect of small changes in aerodynamic shape parameters on the aerodynamic and structural performance of wind turbine blades, a 5 MW offshore wind turbine blade was used as the research object, a CFD aerodynamic model of the blade and a finite element structural model of the composite material were constructed, considering the geometric constraints on the change of the surface shape of the blade element segment caused by the change of a certain airfoil parameter, the test level change of the chord length and twist angle of the blade element segment at different positions were calculated under the premise of satisfying the engineering constraints of the spreading smoothness, and an orthogonal test was designed under the interaction of aerodynamic shape parameters, the effects of aerodynamic shape parameters on aerodynamic torque and tip deflection of wind turbine blades were analyzed by using range analysis and variance analysis for three operating conditions with incoming wind speeds of 8.0, 11.4 and 14.0 m/s. The results show that a 3% change in the test level of the aerodynamic shape parameters can affect about 6.7% of the aerodynamic performance change and about 15.0% of the structural performance change. The main effects of aerodynamic shape parameters are different in different position segments. The interaction between the parameters in different position segments has different degrees of influence on the blade aerodynamic torque and blade tip deflection.
关键词
海上风电 /
风电叶片 /
气动性能 /
结构性能 /
几何约束 /
工程约束 /
交互作用
Key words
offshore wind power /
wind turbine blades /
aerodynamic performance /
structural performance /
geometric constraints /
engineering constraints /
interaction
{{custom_sec.title}}
{{custom_sec.title}}
{{custom_sec.content}}
参考文献
[1] 胡燕平, 戴巨川, 刘德顺. 大型风力机叶片研究现状与发展趋势[J]. 机械工程学报, 2013, 49(20): 140-151.
HU Y P, DAI J C, LIU D S.Research status and development trend on large scale wind turbine blades[J]. Journal of mechanical engineering, 2013, 49(20): 140-151.
[2] 戴巨川, 赵尚红, 尹喜云, 等. 大型风力机叶片气动外形及其运行特性设计优化[J]. 机械工程学报, 2015, 51(17): 138-145.
DAI J C, ZHAO S H, YIN X Y, et al.Design and optimization of aerodynamic shape and operating characteristics of large scale wind turbine blade[J]. Journal of mechanical engineering, 2015, 51(17): 138-145.
[3] CHEN J, WANG Q, ZHANG S Q, et al.A new direct design method of wind turbine airfoils and wind tunnel experiment[J]. Applied mathematical modelling, 2016, 40(3): 2002-2014.
[4] YOSSRI W, BEN AYED S, ABDELKEFI A.Airfoil type and blade size effects on the aerodynamic performance of small-scale wind turbines: computational fluid dynamics investigation[J]. Energy, 2021, 229: 120739.
[5] GIAHI M H,JAFARIAN DEHKORDI A.Investigating the influence of dimensional scaling on aerodynamic characteristics of wind turbine using CFD simulation[J]. Renewable energy, 2016, 97: 162-168.
[6] TAHANI M, MAEDA T, BABAYAN N, et al.Investigating the effect of geometrical parameters of an optimized wind turbine blade in turbulent flow[J]. Energy conversion and management, 2017, 153: 71-82.
[7] 李治国, 郝波, 闫文刚, 等. 凹变翼型对风力机气动性能影响的实验研究[J]. 太阳能学报, 2022, 43(1): 147-153.
LI Z G, HAO B, YAN W G, et al.Experimental study on influence of concave airfoil on aerodynamic performance of wind turbine[J]. Acta energiae solaris sinica, 2022, 43(1): 147-153.
[8] 陈文朴, 李春, 汤金桦, 等. 气动载荷对风力机叶片动态结构特性影响分析[J]. 热能动力工程, 2017, 32(4): 115-119, 143.
CHEN W P, LI C, TANG J H, et al.Influence of aerodynamic loads on dynamic structure characteristics of wind turbine blades[J]. Journal of engineering for thermal energy and power, 2017, 32(4): 115-119, 143.
[9] 张建平, 龚振, 纪海鹏, 等. 额定工况下桨距角对5 MW风力机叶片动力特性的影响[J]. 科学技术与工程,2019, 19(30): 166-171.
ZHANG J P, GONG Z, JI H P, et al.Influence of pitch angle on dynamic characteristics for 5 MW wind turbine blades under rated condition[J]. Science technology and engineering, 2019, 19(30): 166-171.
[10] 郭俊凯, 郭志文, 张建伟, 等. 小型风力机新翼型叶片动态结构响应研究[J]. 太阳能学报, 2021, 42(10): 183-188.
GUO J K, GUO Z W, ZHANG J W, et al.Research of dynamic structure response of small wind turbine blades with new airfoils[J]. Acta energiae solaris sinica, 2021, 42(10): 183-188.
[11] LIU X W, WANG L, TANG X Z.Optimized linearization of chord and twist angle profiles for fixed-pitch fixed-speed wind turbine blades[J]. Renewable energy, 2013, 57:111-119.
[12] 王占飞, 夏鸿建, 李德源, 等. 叶片后掠对风轮结构与气动特性的影响研究[J]. 太阳能学报, 2020, 41(11): 285-292.
WANG Z F, XIA H J, LI D Y, et al.Research on effects of structure and aerodynamic characteristics of back-swept blade wind turbines[J]. Acta energiae solaris sinica, 2020, 41(11): 285-292.
[13] ALKHABBAZ A, YANG H S, SAMITHA WEERAKOON A H, et al. A novel linearization approach of chord and twist angle distribution for 10 kW horizontal axis wind turbine[J]. Renewable energy, 2021, 178: 1398-1420.
[14] JONKMAN J, BUTTERFIELD S, MUSIAL W, et al.Definition of a 5 MW reference wind turbine for offshore system development[R]. Technical Report No.NREL/TP-500-38060, 2009.
基金
国家自然科学基金（51805163）; 湖南省自然科学基金（2019JJ50192）
PDF(2388 KB)
